|
|
|
|
|
|
Re: Kustom V Mixer ( flat base unit ) [message #27682 is a reply to message #27479] |
Mon, 24 February 2020 07:19 ![Go to previous message Go to previous message](/FUDforum/theme/vk30/images/up.png) ![Go to next message Go to next message](/FUDforum/theme/vk30/images/down.png) |
stevem
Messages: 4767 Registered: June 2004 Location: NY
|
Senior Member |
|
|
One of my bands back in the early 70s had one of these mixers and it was made to be used with powered speakers that each contained 2-15" drivers and a Altec type horn as I recall.
These where very basic mixers and I don't even think that there main and monitor outputs where balanced low impeadance, but I could be wrong after all these years!
Other then the issue that it seems your monitor section of the mixer has I can't see what your questioning in regards to running the unit.
You just send the mixers output into a power amp and then the power amp out to speaker!
Many power amps these days have a combo type input jack that accepts both a XLR input or a 1/4' TRS male end.
You would use the 1/4" input on the combo jack, the only thing is that if I am right about the mixer not being low impeadance then your going to have to Crank the mixer up more as running a unbalanced signal into a balanced input power amp will knock 6 db off the the mixers output level.
[Updated on: Mon, 24 February 2020 07:23] Report message to a moderator
|
|
|
|