VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.

Home » VintageKustom.com » Repairing Kustom Amps » Help with fixing Kustom L795RV
Show: Today's Messages :: Polls :: Message Navigator
Return to the default flat view Create a new topic Submit Reply
Help with fixing Kustom L795RV [message #28847] Wed, 16 November 2022 18:59 Go to previous message
Smilan is currently offline  Smilan
Messages: 3
Registered: November 2022
Junior Member
Hi,
I have on the bench a Kustom L795RV that came to me disassembled with burnt resistors at the power amp.
I replaced the faulty resistors and installed new 2N3055 transistors.
Now there's no smoke.
The voltages from the PSU seems to be right.
But what is going on is that as soon as I'm turning the amp on the amp start to squeal and the bulb on the current limiter starting to light bright.
When I disconnected the driver regulator board and connected the signal generator straight to the primary side of the output transformer with the signal on the RED wire and the BLUE wire grounded I got an output signal on the speaker.
When I disconnected the preamp and fed it with 25DCV from external PSU I got output signal on the wire that goes to the driver regulator board.
So it seems like the problem is with this board.
I replaced the three electrolytics on the board and tested all the transistors outside of the board and everything tested good.
Since I don't have a schematic for the L795RV I worked with the "Ross organ amplifier schematic" that I found on EL34 website that is pretty much identical to the driver regulator board and the power section of the L795RV.
What else can I do to make this amp works?
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Frank schematic needed - PC101
Next Topic: I let the smoke out!
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Sat Nov 02 17:58:26 EDT 2024