VintageKustom.com: Replacement Part Suggestions » Suggestion for replacement filter caps on K200A-2?

Home » VintageKustom.com » Replacement Part Suggestions » Suggestion for replacement filter caps on K200A-2?

Show: Today's Messages :: Polls :: Message Navigator

Suggestion for replacement filter caps on K200A-2? [message #28889]

Wed, 11 January 2023 09:36

claussoegaard
Messages: 27
Registered: July 2022

Junior Member

Inside my K200A-2 are two gigantic 4500uF (50V) can caps, with screw terminals on the top. I'm sure this is common in all/most Kustoms from that era. My question - does a suitable replacement for these exist? I'm sure I could find some 4500uF (50V) caps, but I'm thinking more about something in the same or similar form factor?

I don't necessarily have any reason to think they're bad per se, but one measures 6536uF and the other 5340uF on my Fluke, so they're at least a bit out of spec.

I tried searching the forum, but couldn't find anything. Maybe my searching skills need improving. Thanks in advance!

Report message to a moderator

Re: Suggestion for replacement filter caps on K200A-2? [message #28892 is a reply to message #28889]

Thu, 12 January 2023 06:37

stevem
Messages: 4774
Registered: June 2004
Location: NY

Senior Member

I will reply back to you later today since I am at work and without my notes / info.

Report message to a moderator

Re: Suggestion for replacement filter caps on K200A-2? [message #28893 is a reply to message #28889]

Thu, 12 January 2023 06:56

claussoegaard
Messages: 27
Registered: July 2022

Junior Member

Great, thank you Steve - no rush!

Report message to a moderator

Re: Suggestion for replacement filter caps on K200A-2? [message #28894 is a reply to message #28889]

Thu, 12 January 2023 16:55

stevem
Messages: 4774
Registered: June 2004
Location: NY

Senior Member

Mouser electronics has replacement can filters.
There part number is CG452U050V4C, there 45 bucks each.
Yes, can caps are computer grade filters and priced as such.

Report message to a moderator

Re: Suggestion for replacement filter caps on K200A-2? [message #28895 is a reply to message #28889]

Fri, 13 January 2023 03:16

claussoegaard
Messages: 27
Registered: July 2022

Junior Member

Perfect! Those should work just fine. If I do end up replacing them, do you have any tips for how to mount them? The existing caps are 2.5" diameter, and the replacements are 2". Ideally I'd prefer to not drill any new holes, so I'm thinking maybe some padding of some sort around the new caps so I can use the existing 2.5" bracket? Otherwise I guess I'd need new 2" brackets, but I have no idea where to source something like that.

Any advice or guidance would be greatly appreciated!

Report message to a moderator

Re: Suggestion for replacement filter caps on K200A-2? [message #28896 is a reply to message #28889]

Fri, 13 January 2023 03:22

claussoegaard
Messages: 27
Registered: July 2022

Junior Member

...I guess maybe Mouser part VR8B would be the bracket to go for if I wanted a new one. But if there are any good ideas/advice for ways to just keep using the old 2.5" brackets, I'm all ears!

Report message to a moderator