VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.
Home » VintageKustom.com » Repairing Kustom Amps » Vintage circa 1966 "Frankenstein" amp (Need schematic)
Show: Today's Messages :: Polls :: Message Navigator
Switch to threaded view of this topic Create a new topic Submit Reply
Vintage circa 1966 "Frankenstein" amp [message #27459] Wed, 24 July 2019 23:14 Go to next message
Vintage Kustom Employee is currently offline  Vintage Kustom Employee
Messages: 1
Registered: July 2019
Junior Member
I am working on a vintage 1966 Kustom amplifier ("Frankenstein" style) and need any support documentation anyone may have available.

I have been asked by a friend to see if I could fix the unit. This amp has a special nostalgic value as the owner worked at Kustom as the QC operator doing final test with his guitar. He obtained this unit while working there.

Any help with schematics or hand written diagrams would be appreciated.

Report message to a moderator

Re: Vintage circa 1966 "Frankenstein" amp [message #27460 is a reply to message #27459] Thu, 25 July 2019 05:51 Go to previous messageGo to next message
stevem is currently offline  stevem
Messages: 4773
Registered: June 2004
Location: NY
Senior Member
Hello and welcome!

First I have 2 questions for you , that being have you repaired solid state audio electronics before and does this amp you have use round shaped output and regulator Transistors on the rear wall of the amp, or are they kinda oval shaped?

I have just finished repairing two of these very early amps and in my 46 years of repairing band gear / audio electronics and playing in about 9 different bands and using only Kustom gear for my Bass these Kustoms I just fixed are the only of this type I have ever come across!

On these 2 amps I have even though they where made in the same year they are different from each other.

One amp has the output coupling cap as a can type mounted to the chassis and the other has a axial type filter mount to the left side of the circuit board.

I have not been able to find a schematic for these early amps so as such I am finishing drawing up a schematic for them this week that I Can share.

Note that these amps use Germsinum type Transistors and some of these of the bigger type used in the amp are getting very expensive!

Also note that these amps are only about 25 watts of clean power and have very little peak wattage to them.

Please feel free to pm me with any questions and Our good buddy Bill on this site can help you also!

[Updated on: Thu, 25 July 2019 05:53]

Report message to a moderator

Re: Vintage circa 1966 "Frankenstein" amp [message #27487 is a reply to message #27460] Tue, 03 September 2019 22:34 Go to previous message
thetragichero is currently offline  thetragichero
Messages: 33
Registered: April 2019
Member
they don't happen to be 2n555 (not a typo) transistors, do they? i have at least two (and possibly a couple more) that i pulled from organs that i have no use for. worth a couple stamps to get them into something working

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: 795 Speaker Recommendation
Next Topic: Adding A Spring Reverb Tank To A K100-1 50 Watt
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Sun Nov 03 12:56:42 EST 2024
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software