VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.
Home » VintageKustom.com » Comment Board » 3x15 cabinets w/ JBL'S (Question)
Show: Today's Messages :: Polls :: Message Navigator
Switch to threaded view of this topic Create a new topic Submit Reply
3x15 cabinets w/ JBL'S [message #28983] Wed, 15 March 2023 19:08 Go to next message
ThomasG is currently offline  ThomasG
Messages: 2
Registered: March 2023
Junior Member
I have an opportunity to buy a Kustom 3x15 cab with original JBL's. The seller will not allow me to open the cab but I did test it and it sounded great. My question is:
What is the impedance of each speaker and what is the total impedance of the cab?

Thanks in advance!

Report message to a moderator

Re: 3x15 cabinets w/ JBL'S [message #28984 is a reply to message #28983] Wed, 15 March 2023 19:28 Go to previous messageGo to next message
stevem is currently offline  stevem
Messages: 4773
Registered: June 2004
Location: NY
Senior Member
Each speaker if original is 16 ohms.
All three are wired in parallel so with a ohm meter hooked up to a short length cable at the jack you should read less then 6 .5 ohms like 5.3.

If you get a telescoping mechanics mirror you can stick it in one port and put a small flashlight in the othe port and see for sure what's in there.

It could be a bass cab and loaded with D140 JBLs, or it could be a guitar cab and loaded with D130 drivers.

[Updated on: Wed, 15 March 2023 19:34]

Report message to a moderator

Re: 3x15 cabinets w/ JBL'S [message #28985 is a reply to message #28983] Wed, 15 March 2023 19:35 Go to previous messageGo to next message
pleat is currently offline  pleat
Messages: 1454
Registered: June 2004
Location: Belding, Mi
Senior Member
If the cabinet has a slant when viewed from the side, the cab would be for the K200/K400 series amp heads and the speakers are 16 ohm each for a 5.6 ohm total impedance.
If the cab has sliver threads running through the grill cloth and no taper on the side of the cabinet, that cab would be for the K250 series amp heads, and the speakers are 8 ohms each and a total of 2.7 ohms.

Report message to a moderator

Re: 3x15 cabinets w/ JBL'S [message #28987 is a reply to message #28985] Wed, 15 March 2023 19:43 Go to previous messageGo to next message
ThomasG is currently offline  ThomasG
Messages: 2
Registered: March 2023
Junior Member
Thank you for the replies and info. The plaque on the back at the jack says: D130F, so I assume this is a guitar cab andnot a bass cab. The sides are straight, not angled, though I do not recall seeing any silver thread in the grill cloth. All black cloth

Report message to a moderator

Re: 3x15 cabinets w/ JBL'S [message #28990 is a reply to message #28983] Sat, 18 March 2023 06:31 Go to previous message
stevem is currently offline  stevem
Messages: 4773
Registered: June 2004
Location: NY
Senior Member
Yes, it's a guitar cab then with the 130s.

The straight/ vertical front is a early 250 type cab.

There was a point in late 1971 or early 72 where the standard black tuck & roll being used had a much courser texture to it then previous and I believe this is also when the grill cloth with the silver strands in it started to be used.

[Updated on: Sat, 18 March 2023 06:32]

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: K250 Question
Next Topic: K200-B3?
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Sun Nov 03 11:13:07 EST 2024
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software