Kustom III [message #1344] |
Wed, 13 March 2002 21:51 ![Go to next message Go to next message](/FUDforum/theme/vk30/images/down.png) |
Bill
Messages: 64 Registered: March 2002 Location: Kansas
|
Member |
|
|
Hi All,
New to the group...
Where can I get some specs on the Kustom III head I use. It came with what
appears to be a home made cab with one 15" speaker (4 ohm) and a cab with a large
horn with two small horns. The former owner used it with an organ. I play
bass, so use the 15" cab with an old cab of mine with a 12" cts bass
speaker, not a particularly good mix of impedances, but it works. I am considering getting a pair of Carvin or Eminence speakers and building a new ported case.
Just as a side note, back in early 70's I used a Kustom 200 with
two 15" cts speakers. One of these days I hope to find another one, but the
KIII does sound nice, just miss the tuck and roll!
I have enjoyed all the posts, and have learned a lot, plus it brings up a lot of good old memories!
Bill
Parsons, KS
|
|
|
Re: Kustom III [message #1345 is a reply to message #1344] |
Wed, 13 March 2002 22:18 ![Go to previous message Go to previous message](/FUDforum/theme/vk30/images/up.png) ![Go to next message Go to next message](/FUDforum/theme/vk30/images/down.png) |
|
Bill, welcome aboard. The kustom 3 head you have is a 130 watt rms amp into a 4 ohm load. A 2x15 set up sounds like the way to go. You can safely run the amp with a 8 ohm load also. To bad I'm in michigan, I have a couple of extra T&R 2x15 cabinets I am going to be parting with. Don
|
|
|
|