VintageKustom.com: Repairing Kustom Amps » Kustom Studio 4V

Home » VintageKustom.com » Repairing Kustom Amps » Kustom Studio 4V - Schematic needed (Restauration of a butchered Amp)

Show: Today's Messages :: Polls :: Message Navigator

Re: Kustom Studio 4V - Schematic needed [message #29260 is a reply to message #29259]

Mon, 03 June 2024 08:47

electrip_flip
Messages: 2
Registered: May 2024

Junior Member

Hello stevem,

already ordered the schematics.
No fuses dead.
Both PT and OT are fine.
Humdinger resistors literaly disappeared and left a black area.
Funny is Tubes are still heating.
10R Kathode resistors are gone on two tubes.

I expect only minor damages but I have to check those driver bjts.
One connector is missing. Wires were soldered on.

I have to order some parts and a set of 6L6.
Unit is set up for 220V mains,
will set up for 240V and then check heater voltage.
HT unloaded was 527V DC, 383 AC @233V mains

Will need some days for Progress.
Thanks for your Support.

electripflip

Report message to a moderator

[Message index]

		Kustom Studio 4V - Schematic needed By: electrip_flip on Fri, 31 May 2024 15:12
		Re: Kustom Studio 4V - Schematic needed By: stevem on Mon, 03 June 2024 06:26
		Re: Kustom Studio 4V - Schematic needed By: electrip_flip on Mon, 03 June 2024 08:47

Previous Topic:	Repair Inquiry
Next Topic:	pot meters

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Jul 29 10:23:04 EDT 2024