using modern effects [message #24929] |
Sat, 23 April 2016 15:49 ![Go to next message Go to next message](/FUDforum/theme/vk30/images/down.png) |
efinger
Messages: 18 Registered: April 2010 Location: North Carolina
|
Junior Member |
|
|
i use alot of different effect pedals with my kustoms. Are there any precautions to take when using modern pedals with the amps? I read on the site that you could possibly break some of the internals when using certain effects.
thank you!
|
|
|
|
|
|
|
Re: using modern effects [message #24935 is a reply to message #24929] |
Sun, 24 April 2016 06:51 ![Go to previous message Go to previous message](/FUDforum/theme/vk30/images/up.png) ![Go to next message Go to next message](/FUDforum/theme/vk30/images/down.png) |
stevem
Messages: 4772 Registered: June 2004 Location: NY
|
Senior Member |
|
|
Yes, you can pop the first gain stage transistor in any solid state amp not just Kustom's by pumping in too hot / high a signal level in!
This is likely one of the reasons why they started building distortion circuits into SS amp even though all of them sound pretty poor, but hey go back and listen to that crappy sound on the intro to Satisfaction with that Gibson stomp box, so I guess it's a matter of what you grew up with!
The way to set up any SS amp to be safe is to have the volume of your pedal output drive the amp to be no more than let's say 25 to 50 % louder then your guitar would be if you where plugged straight into the amp.
If you have a voltmeter you hook it up across you input cable , set it for AC volts and confirm that on your most pedal boosted setting that you read no more than 1 volt.
Some mid way hot humbuckers can crank out 3/4 / .750 of a volt all on there own, and then again Some of Mr Ds Strat style humbuckers can't top .200 volt, and Kustoms where set up to get this .200 volt or less of input signal to a loud volume!
You need to watch it with modern keyboards also as the Rhodes and and other keyboards of back then output nothing like the stuff from the late 70s on up!
[Updated on: Sun, 24 April 2016 06:55] Report message to a moderator
|
|
|
Re: using modern effects [message #24938 is a reply to message #24935] |
Sun, 24 April 2016 22:26 ![Go to previous message Go to previous message](/FUDforum/theme/vk30/images/up.png) |
efinger
Messages: 18 Registered: April 2010 Location: North Carolina
|
Junior Member |
|
|
thank you sir! for the reply. So basically dont turn your pedals up too loud on SS amps. Ill keep their output below the guitar pots for now. I will try messing about with volt/amp meters with my gear, guitars, etc and see what they are putting out. Never really thought how their output would translate into different voltages. No brainer i guess. Should be interesting to mess around with and learn from. thank you for the tips.
|
|
|