K100 with (2) 4-12" PA Cabinets [message #9715] |
Sat, 27 September 2008 01:16 ![Go to next message Go to next message](/FUDforum/theme/vk30/images/down.png) |
hawk-bass
Messages: 2 Registered: January 2008 Location: Minneapolis, MN
|
Junior Member |
|
|
I'm new here and it was nice to find this site, great job. I went through the postings and didn't find the answers I needed but did find a lot of good stuff.
I have a couple things to ask about if that's cool. I picked up a K100-B5, 4 channel PA head. There are no markings on the back of the amp (besides serial #plate) as to which are 1/4" output jack. I would assume it to be the 2 together up higher and in the center and the lower right had corner might be for a reverb foot switch? Also there is an RCA jack, is that standard?
Now for the cabinet question, as most of the wiring was totally gone inside when I got opened them, are they wired for 8ohm each for a 4 ohm load at the head?
Lastly, just wondering if you will be able to get the schematics back up? Retired road guy now playing for the fun of it, but I can still read a schematic.
Thanks
Hawkeye
Hawkeye
|
|
|
|
|
Re: K100 with (2) 4-12" PA Cabinets [message #9723 is a reply to message #9718] |
Thu, 02 October 2008 18:56 ![Go to previous message Go to previous message](/FUDforum/theme/vk30/images/up.png) |
hawk-bass
Messages: 2 Registered: January 2008 Location: Minneapolis, MN
|
Junior Member |
|
|
Silver, found it at a pawn shop. Not a scratch on it. The speakers are a bit tough, but just for rehearsal room they're OK.
I found a stand for the head but need the clamp set for the cabinet, it just has the screws left in it, any ideas if those can even be found anywhere?
Thanks for the info too!I appreciate it.
Hawkeye
Hawkeye
|
|
|