VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.

Home » VintageKustom.com » Repairing Kustom Amps » 250-4 (got it burnt up to repair on my bech)
Show: Today's Messages :: Polls :: Message Navigator
Return to the default flat view Create a new topic Submit Reply
250-4 [message #28618] Wed, 22 June 2022 16:29 Go to previous message
kb0rex is currently offline  kb0rex
Messages: 33
Registered: June 2022
Member
got brought a 250-4 from garage sale got it for 50 bucks... I can see why. It's smoked 9 ways to Sunday. Customer got this in black with the speakers wants the pa repaired. Found this site pulled the schematics. Someone had tried to repair and had no idea as the outputs were all the same wiring (2 backwards) the usual suspects 95.3 681s and 1ks burnt in half. driver also shorted. Relaced all the above and it's somewhat alive, has a nasty hum but does pass signal now that the effects board is also repaired the ic1 op amp 1/2 gone. reverb tremolo and vibrato good. It now limps along. It runs hot and thermal on the heat sink will shut it down. the 5065 board seems to still have issues, but I am apparently too dumb to figure it out, its pulling the power supply down to 37+- volts. I had no voltage on the outputs but after going back over the board and putting in the correct 95.3 and 681s I also tried using 4007s for cr1 and 2 as they tested better than the old white ones in there. I also thought this might clean up the Humm and heat but not I have a +1 volt or so on output . Steve or Bill I seem to be thrashing on this one. Work on lots of amps first time Kustom although it seems like a interesting amp built like a tank. Thanks Doug
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: K200 Bright Channel is ALIVE...
Next Topic: Krossroad 500 "pops" when powered off
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Fri Nov 01 13:21:04 EDT 2024