VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.

Home » VintageKustom.com » Repairing Kustom Amps » 250-4 (got it burnt up to repair on my bech)
Show: Today's Messages :: Polls :: Message Navigator
Return to the default flat view Create a new topic Submit Reply
Re: 250-4 [message #28619 is a reply to message #28618] Thu, 23 June 2022 15:49 Go to previous messageGo to previous message
chicagobill
Messages: 2006
Registered: April 2003
Senior Member
Welcome to the place.

I would first fix the power amp problems before working on the FX and the preamps. Almost all of the Kustom power amps use the same basic architecture, and are really basic. All the major manufacturers have used the same basic design for the past 40-50 years. You should not have any problem getting it figured out.

If the power amp is overheating, then there probably is a balance problem between the two halves of the output section. This can also be the source of the hum and of the voltage on the output. I don't know if you have a light bulb limiter available, but if you do, use it until you get the power amp working. Check all of the transistors in the power amp and take voltage readings to see if they come close to the listed schematic values.

The 1N3754 diode that clips to the heat sink is fragile, so be careful while you are working on the amp.
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: K200 Bright Channel is ALIVE...
Next Topic: Krossroad 500 "pops" when powered off
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Fri Nov 01 15:07:41 EDT 2024