VintageKustom.com: Comment Board » Happy Newbie with a K-150

Home » VintageKustom.com » Comment Board » Happy Newbie with a K-150 (Date code help?)

Show: Today's Messages :: Polls :: Message Navigator

Happy Newbie with a K-150 [message #25735]

Sat, 31 December 2016 00:26

Midlife
Messages: 3
Registered: December 2016
Location: GA

Junior Member

Greetings - First of many posts I hope. Just acquired a nearly pristine K-150-1 Bass amp. Pwr switch not working - fixed with zip ties but neither switch illuminates. still has 2 prong power.

SN is 84927, when was it made?

How do I replace the switch bulbs?

What is the right way to 3 wire it?

Thanks in advance for your wisdom and experience.

SG

Steve

Report message to a moderator

Re: Happy Newbie with a K-150 [message #25737 is a reply to message #25735]

Sat, 31 December 2016 14:10

Midlife
Messages: 3
Registered: December 2016
Location: GA

Junior Member

Thanks!

Steve

Report message to a moderator

Re: Happy Newbie with a K-150 [message #25738 is a reply to message #25735]

Mon, 02 January 2017 08:34

stevem
Messages: 4775
Registered: June 2004
Location: NY

Senior Member

Hello!
Your amp was born between Jan and June 1972.
The pilot lamp bulbs you need are GE 335 which can be had from many sources , order some spares as they are cheap!

The best way to replace them is to unscrew the mounting bracket that they are threaded on to from the inside face of the amp, then pull the Blue lens off of them and the I use some automotive vacuum tubing to slip over the bulbs to both unscrew them, and install the new bulbs.

Note , I do have new complete switches for these heads but there are 60 bucks before the shipping cost.

While you are in there you should clip out the grounding cap from the polarity switch.

Report message to a moderator

Re: Happy Newbie with a K-150 [message #25739 is a reply to message #25738]

Mon, 02 January 2017 10:59

Midlife
Messages: 3
Registered: December 2016
Location: GA

Junior Member

Thanks Much! I'm loving this vintage amp! Silly newbie question - why 2 sets of two inputs - what's the intended difference? I looked online for an old manual reprinted or scanned but no luck

Steve

Report message to a moderator

Re: Happy Newbie with a K-150 [message #25740 is a reply to message #25739]

Mon, 02 January 2017 16:36

pleat
Messages: 1454
Registered: June 2004
Location: Belding, Mi

Senior Member

The lower jack on each channel has more gain than the top jack of each channel. Reason might be back in the day you could select either jack, upper for humbucking guitars and the lower jack for single coil pickup guitars.

I know back in the 50's and 60's there were a lot of bands that would share an amp, hence the two independent channels.

pleat

Report message to a moderator

Previous Topic:	Vintage Kustom Sighting
Next Topic:	Kustom Grille Cloth Minutiae

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Tue Nov 19 05:32:21 EST 2024