250 Bass Amp Head [message #28078] |
Fri, 05 March 2021 00:42 ![Go to next message Go to next message](/FUDforum/theme/vk30/images/down.png) |
chemita57
Messages: 3 Registered: March 2021
|
Junior Member |
|
|
Do the small rivets on the sides of the rear panel of the amp head need to be drilled out to pull out the electronics?
|
|
|
Re: 250 Bass Amp Head [message #28079 is a reply to message #28078] |
Fri, 05 March 2021 05:33 ![Go to previous message Go to previous message](/FUDforum/theme/vk30/images/up.png) ![Go to next message Go to next message](/FUDforum/theme/vk30/images/down.png) |
stevem
Messages: 4772 Registered: June 2004 Location: NY
|
Senior Member |
|
|
The complete chassis slides out the rear of the cabinet by removing the four 10/32 machine screws on the bottom of the cabinet, do not remove the 4 metal feed on the bottom if they are still there.
Do not drill out the riviets as they hold the chassis together . Why is it you need to gain access to the inside of the amp
[Updated on: Fri, 05 March 2021 05:37] Report message to a moderator
|
|
|
|
|
Re: 250 Bass Amp Head [message #28086 is a reply to message #28078] |
Sat, 06 March 2021 11:37 ![Go to previous message Go to previous message](/FUDforum/theme/vk30/images/up.png) |
stevem
Messages: 4772 Registered: June 2004 Location: NY
|
Senior Member |
|
|
The bulbs are a number 335 and can be removed and installed from the front of the amp much easier then from the inside of the amp by using needle nose plyers to carefully remove the blue lens from the face of the switch.
Use some clear tubing to remove the old bulb and install the new one.
Do a search on line for the bulbs, I think I saw some on Amazon.
|
|
|