VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.

Home » VintageKustom.com » Replacement Part Suggestions » Licon switch replacement
Show: Today's Messages :: Polls :: Message Navigator
Return to the default flat view Create a new topic Submit Reply
Re: Licon switch replacement [message #14519 is a reply to message #14517] Wed, 06 October 2010 12:49 Go to previous messageGo to previous message
dndemattia is currently offline  dndemattia
Messages: 6
Registered: September 2010
Location: USA
Junior Member

Stevem,

Thanks! The ground wire modification had already been made before the amp came to me. My main problem is that the current limiting resistor I put on the new LED switch is getting very hot while the power switch LED is not. Both dropping resistors are 3.3k 1/2 watt in series with the 400 ohm 10w dropping resistor already in the amp.
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Kustom K200D Bass Guitar tuners?
Next Topic: Sidewinder Diode CR1 & CR2 replacement (part no: 007-6011-00)
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Sun Nov 17 23:08:51 EST 2024