VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.

Home » VintageKustom.com » Repairing Kustom Amps » Kustom III PA (Output transistors)
Show: Today's Messages :: Polls :: Message Navigator
Return to the default flat view Create a new topic Submit Reply
Re: Kustom III PA [message #22790 is a reply to message #22767] Wed, 22 April 2015 16:11 Go to previous messageGo to previous message
Autoharp is currently offline  Autoharp
Messages: 14
Registered: April 2015
Location: Warren, MI
Junior Member
Pulled the 5065 module out...interesting...

It shows the bias diodes as the two clipped in on the heat sink and a third on the board - but the one that BELONGS on the board is not there; it is where the 33+10 ohm combination is. I have lots of diodes here, I just need to figure out what a generic type is that will work in its place.

AND - the emitter lead is broken off (at the connector) from one of the output transistors. This can't be good either.

So I have someplace to start...


Autoharp Bill
Beautiful Downtown
Warren, Michigan
USA
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message icon7.gif
Read Message
Previous Topic: C795 Frankie
Next Topic: '60's 2x12" cabinet impedance?
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Fri Jan 10 06:57:35 EST 2025