VintageKustom.com: Comment Board

Home » VintageKustom.com » Comment Board » Kustom 150-1 (To Tape Record)

Show: Today's Messages :: Polls :: Message Navigator

Kustom 150-1 [message #27818]

Fri, 24 July 2020 17:16

SASal
Messages: 2
Registered: December 2016
Location: San Antonio, Texas

Junior Member

Can someone please tell me what the input on the back of my amp is for. It says "To Tape Record".

Sal

Report message to a moderator

Re: Kustom 150-1 [message #27819 is a reply to message #27818]

Sat, 25 July 2020 05:27

stevem
Messages: 4775
Registered: June 2004
Location: NY

Senior Member

It's a unbalanced signal output jack.

It can supply about 3 volts of signal level to a old time tape recorder or to a power amp.

In terms of feeding a power amp since you would be going in to the amp unbalanced you would only have enough drive signal to push the power to about 1/2 its full rated output wattage.

You could also concider this output from the amp a effect send, so you could then go out of a effect , pad it down and go back into the second channel of the Kustom if you where not using it.

Report message to a moderator

Re: Kustom 150-1 [message #27821 is a reply to message #27819]

Sat, 25 July 2020 21:14

SASal
Messages: 2
Registered: December 2016
Location: San Antonio, Texas

Junior Member

OK thanks man.

Sal

Report message to a moderator

Re: Kustom 150-1 [message #27831 is a reply to message #27818]

Tue, 18 August 2020 12:47

rvasoundguy
Messages: 7
Registered: August 2020

Junior Member

I just tried using this on a 200B-1 for a direct out to my Midas board. I used one channel of an old Rane direct box that has 2 RCA in and is transformer balanced to 2 XLRs. It works great. I though it might be noisy but its not.

Report message to a moderator

Previous Topic:	Amp identification
Next Topic:	New to me 1969 200B-1 with 215

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Tue Nov 12 04:16:52 EST 2024