VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.
Home » VintageKustom.com » Repairing Kustom Amps » repairing k150-8 plexi (troubleshooting blowing fuses)
Show: Today's Messages :: Polls :: Message Navigator
Return to the default flat view Create a new topic Submit Reply
Re: repairing k150-8 plexi [message #24183 is a reply to message #24179] Sun, 29 November 2015 07:29 Go to previous messageGo to previous message
stevem is currently offline  stevem
Messages: 4754
Registered: June 2004
Location: NY
Senior Member
Your DC voltages will be high once parts of the output stage blow open , the high voltage is due to the circuit not pulling the current is should .
It's time to start pulling the two output transistors on the heat sink strip and checking them and performing a resistance check on the two 5 watt ciramic box resistors.

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Frankenstein Head: replacement cap values
Next Topic: Kustom 200 A-4 (Earlier)
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sat Jul 20 03:16:12 EDT 2024
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software