VintageKustom.com: Comment Board

Home » VintageKustom.com » Comment Board » K200B4

Show: Today's Messages :: Polls :: Message Navigator

K200B4 [message #9061]

Wed, 19 December 2007 11:40

teleman
Messages: 38
Registered: June 2004

Member

Is there a way to link the right channel effects to the verb/trem channel on a K200B4?

Report message to a moderator

Re: K200B4 [message #9062 is a reply to message #9061]

Wed, 19 December 2007 12:05

chicagobill
Messages: 2006
Registered: April 2003

Senior Member

I don't think that there is any simple way to get all of the FX into one channel, unless you run the two channels in parallel. Of course this means that you will hear all of the FX, but probably not the way you want them.

It would probably be easier to add the vibrato and reverb to the right channel signal than the other way around. To do this, you would need to re-route the output from the right channel into the FX sections of the left channel, and then into the power amp.

You could add a switch that would disable the front section of the left channel and route the signal from the right channel over to the vibrato and the reverb sections.

Report message to a moderator

Re: K200B4 [message #9063 is a reply to message #9062]

Wed, 19 December 2007 18:49

teleman
Messages: 38
Registered: June 2004

Member

Thanks for the technical info. I was just wondering if that could be done. I don't have a A4 or B4 and they seem to be getting hard to find and expensive. I have a Black K100-2 and a Black K200B-2. If one could obtain a PC407A effects board I think it could be done with the B-2 but there would be a little more work involved. Black Kustoms rule!

Report message to a moderator

Previous Topic:	3X15 fun
Next Topic:	PC402 or ?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Sat Nov 02 21:03:14 EDT 2024