VintageKustom.com: Comment Board » New to the board and to the tuck and roll.

Home » VintageKustom.com » Comment Board » New to the board and to the tuck and roll. (Few noobish Q's)

Show: Today's Messages :: Polls :: Message Navigator

Re: New to the board and to the tuck and roll. [message #23848 is a reply to message #23786]

Mon, 14 September 2015 06:33

stevem
Messages: 4758
Registered: June 2004
Location: NY

Senior Member

Just unplugging the reverb cables may not be enough to stop any 60 hz hum from the power transformer that may be coming thru.
Try this.
With both cables plugged into the board turn the reverb control up and tap each end of each cable.

On one cable you will hear a buzz when doing that, and that will be the cable that you want to short out across itself.

If the cables are not the thick gray stock ones but are thin replacements then just cut the cable off, strip it and twist the wire together. This will short the input to the recovery amp and may be kill off some hum.

When doing this with the amp on stay clear of any of the wires with the wall outlet voltage on them near the on/ off switch and the fuse area!

[Updated on: Mon, 14 September 2015 06:36]

Report message to a moderator

[Message index]

		New to the board and to the tuck and roll. By: Mr.Toast on Tue, 08 September 2015 20:03
		Re: New to the board and to the tuck and roll. By: stevem on Tue, 08 September 2015 20:23
		Re: New to the board and to the tuck and roll. By: Iowa Boy on Wed, 09 September 2015 20:42
		Re: New to the board and to the tuck and roll. By: stevem on Thu, 10 September 2015 05:49
		Re: New to the board and to the tuck and roll. By: Iowa Boy on Fri, 11 September 2015 00:34
		Re: New to the board and to the tuck and roll. By: stevem on Fri, 11 September 2015 05:57
		Re: New to the board and to the tuck and roll. By: Iowa Boy on Fri, 11 September 2015 09:40
		Re: New to the board and to the tuck and roll. By: Mr.Toast on Fri, 11 September 2015 17:26
		Re: New to the board and to the tuck and roll. By: pleat on Fri, 11 September 2015 19:09
		Re: New to the board and to the tuck and roll. By: Iowa Boy on Fri, 11 September 2015 19:54
		Re: New to the board and to the tuck and roll. By: Mr.Toast on Sat, 12 September 2015 08:57
		Re: New to the board and to the tuck and roll. By: Iowa Boy on Sat, 12 September 2015 12:06
		Re: New to the board and to the tuck and roll. By: chicagobill on Sat, 12 September 2015 22:35
		Re: New to the board and to the tuck and roll. By: stevem on Sun, 13 September 2015 06:34
		Re: New to the board and to the tuck and roll. By: Mr.Toast on Sun, 13 September 2015 11:56
		Re: New to the board and to the tuck and roll. By: Iowa Boy on Sun, 13 September 2015 13:09
		Re: New to the board and to the tuck and roll. By: pleat on Sun, 13 September 2015 15:09
		Re: New to the board and to the tuck and roll. By: Iowa Boy on Sun, 13 September 2015 15:53
		Re: New to the board and to the tuck and roll. By: stevem on Mon, 14 September 2015 06:33
		Re: New to the board and to the tuck and roll. By: C4ster on Mon, 14 September 2015 10:27
		Re: New to the board and to the tuck and roll. By: Iowa Boy on Mon, 14 September 2015 11:04
		Re: New to the board and to the tuck and roll. By: stevem on Mon, 14 September 2015 11:05
		Re: New to the board and to the tuck and roll. By: Iowa Boy on Mon, 14 September 2015 14:15
		Re: New to the board and to the tuck and roll. By: stevem on Mon, 14 September 2015 14:55
		Re: New to the board and to the tuck and roll. By: Mr.Toast on Mon, 14 September 2015 20:06
		Re: New to the board and to the tuck and roll. By: Iowa Boy on Mon, 14 September 2015 23:43
		Re: New to the board and to the tuck and roll. By: stevem on Tue, 15 September 2015 06:26
		Re: New to the board and to the tuck and roll. By: Iowa Boy on Tue, 15 September 2015 22:03
		Re: New to the board and to the tuck and roll. By: Mr.Toast on Wed, 16 September 2015 17:56

Previous Topic:	KEI 15in Speakers
Next Topic:	Coming Clean

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Sat Aug 17 02:53:26 EDT 2024