VintageKustom.com: Comment Board » What to connect Kustom K250-4

Home » VintageKustom.com » Comment Board » What to connect Kustom K250-4

Show: Today's Messages :: Polls :: Message Navigator

Re: What to connect Kustom K250-4 [message #9236 is a reply to message #9230]

Mon, 18 February 2008 06:28

stevem
Messages: 4754
Registered: June 2004
Location: NY

Senior Member

Some added detail for you when you check the cabinets.
A 16 ohm cabinet will test out above 8 ohms but less than 16 ohms.
A 8 ohm cabinet will test under 8 ohms, but over 4 ohms, and 4 ohms, I think you get the pattern.
If your 2-15" cab has the original speakers it will be a 4 or 8 ohm cabinet.
If its 8 ohms you are set, all you have to do is Y the Kustom and the Fender cabinet together, in fact I think the Fender cab as two jacks so you can just plug the head into the fender cab first, and then run another speaker cable to the 2-15" cab.
This will be a 4 ohm load and the 250 head will output its full wattage witha 3 to 4 ohm load.

If the 2-15" kustom cab turns out to be 4 ohm, you can still use the Fender and the Kustom cabinet, but you will have to make up a cable to run them in serise not in parallel like I discribed before.
With this wiring the 4 ohm (Kustom cabinet) will be getting twice the wattage as the fender due its its lower resistance, and as such may seem a little louder than the Fender, but since the Fender has 2 more speakers I will guess that with its added spl level they will both seem to be just as loud as each other.

With the serise wiring the Kustom will only be able to output about 80 watts RMS, not its 100 or more watts, but the added 4 speakers will well more than make up for it!

Report message to a moderator

[Message index]

		What to connect Kustom K250-4 By: frans on Thu, 14 February 2008 11:11
		Re: What to connect Kustom K250-4 By: stevem on Thu, 14 February 2008 12:33
		Re: What to connect Kustom K250-4 By: frans on Fri, 15 February 2008 10:35
		Re: What to connect Kustom K250-4 By: chicagobill on Fri, 15 February 2008 10:47
		Re: What to connect Kustom K250-4 By: frans on Fri, 15 February 2008 15:59
		Re: What to connect Kustom K250-4 By: chicagobill on Fri, 15 February 2008 18:08
		Re: What to connect Kustom K250-4 By: johnnysynth on Tue, 06 August 2019 07:30
		Re: What to connect Kustom K250-4 By: stevem on Mon, 18 February 2008 06:28

Previous Topic:	Kustom Column info
Next Topic:	Impedence of JBL D140F

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Jul 18 05:45:06 EDT 2024