need kustom 200a-5 schematics [message #17423] |
Wed, 29 August 2012 19:08 |
jassman
Messages: 9 Registered: August 2012 Location: montreal
|
Junior Member |
|
|
Hello fellow Kustom fans,
I have a Kustom 200a-5 4 channel amp.I am in need of the following schematics, PC502, PC602, PC102, PC702. Can anyone let me know where I can get them...free?
Much appreciated,
Michael
|
|
|
|
|
Re: need kustom 200a-5 schematics [message #17427 is a reply to message #17423] |
Sat, 01 September 2012 00:27 |
chicagobill
Messages: 2005 Registered: April 2003
|
Senior Member |
|
|
No problem. To answer your question regarding the blown fuse, the two main reasons for blown fuses are shorted transistors (output and driver) and shorted power supply diodes.
If you have a multimeter with a diode test function, use it to test the output transistors. The most common failure is a short between Collector and Emitter. If you do find one or more shorted ones, test the drivers as well as the emitter resistors.
|
|
|
|
|
|
|
|
|
Re: need kustom 200a-5 schematics [message #17436 is a reply to message #17423] |
Tue, 04 September 2012 00:38 |
chicagobill
Messages: 2005 Registered: April 2003
|
Senior Member |
|
|
You have been getting advice from Steve as well as from me, so thanks go to him as well.
All reverb tanks will make noise when they are shaken up, but the springs (reverb and mounting) can get stretched out from age and vibrations. You could try a new tank to see if it makes less noise.
|
|
|
|
|
|