Kustom K200 -5 pa [message #23585] |
Tue, 11 August 2015 12:12 ![Go to next message Go to next message](/FUDforum/theme/vk30/images/down.png) |
mthomas71
Messages: 4 Registered: August 2015 Location: Pensacola fl
|
Junior Member |
|
|
New member first post. Just putchased a K200-5 pa not sure the year ser. #78181. It has 4 channels each volume, bass, treble, and reverb. Has any modded there amp so tbat you get a different sound from each channel. I heard Robert Hinson out of Memphis does great mods but I have searched every where and cant find any contact information.
Thanks for help you can provide.
Mike
|
|
|
|
|
|
|
Re: Kustom K200 -5 pa [message #23604 is a reply to message #23585] |
Wed, 12 August 2015 01:12 ![Go to previous message Go to previous message](/FUDforum/theme/vk30/images/up.png) ![Go to next message Go to next message](/FUDforum/theme/vk30/images/down.png) |
chicagobill
Messages: 2005 Registered: April 2003
|
Senior Member |
|
|
Pleat is right, all 4 of the channel preamp boards are the same as used on the guitar amps. But when the reverb control is added for the PA, a jumper is added that replaces the bright on and off switch that is the same as turning on the bright switch.
You might be able to change a few cap values to alter the tone of a channel.
|
|
|
|
|
Re: Kustom K200 -5 pa [message #23615 is a reply to message #23585] |
Wed, 12 August 2015 19:08 ![Go to previous message Go to previous message](/FUDforum/theme/vk30/images/up.png) |
stevem
Messages: 4758 Registered: June 2004 Location: NY
|
Senior Member |
|
|
Well with less than a bucks worth of parts you could simple make one Channel into a brite channel by paralleling a .005 uf 10 volt cap across a 470K resistor and wire this in before the blue wire off of one of the 4 input jacks , you can then use a Y cord, or a A/B box and blend the two channels to your liking.
Certain caps on any of the boards could be changed to less or more mids, or roll off some of the Bass.
|
|
|