VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.
Home » VintageKustom.com » Repairing Kustom Amps » Kustom 200 making a cracking noise
Show: Today's Messages :: Polls :: Message Navigator
Switch to threaded view of this topic Create a new topic Submit Reply
Kustom 200 making a cracking noise [message #4161] Fri, 07 May 2004 14:55 Go to next message
Anonymous
just got a Kustom 200. It make a loud cracking sound when I play on it.the sound still comes through but also the cracking noise.what could be causing this?

Report message to a moderator

Re: Kustom 200 making a cracking noise [message #4165 is a reply to message #4161] Fri, 07 May 2004 23:15 Go to previous messageGo to next message
VinceG2
Messages: 26
Registered: April 2004
Junior Member
A lot of things can causing crackling. Is it on one or both channels? Have you tried another guitar cable? If it's just one one channel, it could be oxidation on the jack..try plugging and unplugging a guitar cord into it a bunch of times..you can use some de-oxit with it to clean it. If that doesn't help, then it could be bad resistors or capacitors can cause crackling. Using some freeze spray can probably track down any bad ones quickly, if you know what you're doing. If not, take it to a repair place..the tech should be able to trace it pretty quickly. Maybe Steve has some other ideas on crackling.

Report message to a moderator

Re: Kustom 200 making a cracking noise [message #4166 is a reply to message #4165] Fri, 07 May 2004 23:25 Go to previous messageGo to next message
VinceG2
Messages: 26
Registered: April 2004
Junior Member
Oops, I forgot to mention, if it crackles when you adjust one of the controls, it could be a dirty or worn pot..cleaning the pot with some tuner spray could stop that. Just make sure the spray doesn't leak all over the circuit board..use some paper towels to catch the overspray.

Report message to a moderator

Re: Kustom 200 making a cracking noise [message #4189 is a reply to message #4161] Thu, 13 May 2004 10:04 Go to previous message
pleat is currently offline  pleat
Messages: 1454
Registered: June 2004
Location: Belding, Mi
Senior Member
It sounds like it has a componet that has broken loose from a circuit board. I have seen this in a lot of older amps. Lot of rough handling, and the heavy caps, can break loose. GE silicon glue was used to hold the big blue or orange caps to the boards, to solve the leads breaking free. Dirty controls usually quiet down once the control is set, but it never hurts to clean them. One way to help track down the noise is, the noise heard in all the channels, if so, then I would suspect the power amp section has the problem. If only one of the channels makes the noise, then I would look at that channel. Hope this helps, Don

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: K250-2 Reverb Tank repair tip
Next Topic: Reverb in a Kustom
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Thu Aug 22 04:55:44 EDT 2024
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software