Help [message #17681] |
Fri, 16 November 2012 14:03 |
Cowboy
Messages: 6 Registered: November 2012
|
Junior Member |
|
|
Does anyone have any idea for a replacement transformer for a K100. The primary voltage was measured at 118v and 59 to 61v on the secondaries.
That is all I know other then it got really hot due to the external recterfier bridge failure. I replace the bridge and the amp worked for a short time, but then the Transformer finally gave up.
|
|
|
Re: Help [message #17691 is a reply to message #17681] |
Fri, 16 November 2012 22:34 |
chicagobill
Messages: 2006 Registered: April 2003
|
Senior Member |
|
|
The obvious answer is a dead donor amp. There is seller on eBay that is selling nos power transformers from a Musicman bass amp that would probably work, but you will need to find a way to mount it.
Maybe one of the guys here has a donor head that still has a good transformer.
|
|
|
|
|
|
|
|
|
|
Re: Help [message #17715 is a reply to message #17681] |
Sun, 18 November 2012 14:48 |
chicagobill
Messages: 2006 Registered: April 2003
|
Senior Member |
|
|
Pleat, I think the 40 volts that you are referring to is the plus and minus dc voltage after the rectifier, that is used to power the main power amp.
The 60 volts is the ac output directly from the power transformer which is center tapped, creating two 30 volt taps that are then rectified to get the 40 volts dc.
The basic theory is that the ac voltage times 1.4 gives you the dc voltage for the power supply. So 30vac X 1.4 = 42vdc.
Cowboy, if you can't find one check the eBay listing for the Musicman power transformer that I mentioned before, it's something like $30 shipped and should work fine with no mods to the amp, as long as you can find a way to get it mounted.
|
|
|
|
|
|
Re: Help [message #17732 is a reply to message #17681] |
Wed, 21 November 2012 06:51 |
stevem
Messages: 4772 Registered: June 2004 Location: NY
|
Senior Member |
|
|
The 39.5 volts that most kustoms run on is the voltage output from the PT with the amp at idle a drawing current, unloaded it will be higher, with the amp running at full max wattage the 39.5 volts will dip to around 32 to 34 volts.
The Torid PT I posted about is step up due to it being a torid, also it has more current output so the amp will output more power and give more clean head room, also being a Torid type it will put out less 60 hz hum into the reverb pan/output.
|
|
|