Power handling of PCB traces [message #4723] |
Sun, 22 August 2004 20:20 ![Go to next message Go to next message](/FUDforum/theme/vk30/images/down.png) |
rodak
Messages: 514 Registered: October 2001 Location: Georgia
|
Senior Member |
|
|
I've got some nice 12,000uf, 63V electrolytics I want to put in my Kombo organ power supply. Trouble is, they're pc-mount caps, so I made a little PCB for them, and ran traces out to four holes, where I've epoxied nuts to fit the screws that go in the existing caps, so it'll be a sort of drop-in replacement module. But I began wondering, will PC-board traces handle the power demands of this power supply? And if so, how wide should the traces be? I don't think I've ever seen this topic addressed before.
www.combo-organ.com
|
|
|
Re: Power handling of PCB traces [message #4727 is a reply to message #4723] |
Mon, 23 August 2004 09:46 ![Go to previous message Go to previous message](/FUDforum/theme/vk30/images/up.png) |
stevem
Messages: 4758 Registered: June 2004 Location: NY
|
Senior Member |
|
|
HI, the power supply runs at 40VDC, to put out 100 watts RMS thats anywhere from 2.5 to 5 amps the supply has to put out depending on the speaker ohm load. To be safe I would run a bead of solder to cover the traces, or tack down some buss wire.
|
|
|