VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.

Home » VintageKustom.com » Comment Board » K 250-4 amp
Show: Today's Messages :: Polls :: Message Navigator
Return to the default flat view Create a new topic Submit Reply
Re: K 250-4 amp [message #15609 is a reply to message #13235] Tue, 10 May 2011 11:36 Go to previous messageGo to previous message
Van
Messages: 134
Registered: April 2004
Senior Member
>>1. Is the pot actually 10K ohm rather than 10 ohm?<<

Yes! 10k ohm. Sorry. Pesky little "k"! Wink

>>2. Any chance you could shoot a picture of how you wired the plug? In digging through other posts it sounds like it was wired unconventionally with the ground wire to the tip of the plug?<<

I used a stereo molded plug and just cut one end off.
I'm sure the ground was probably bottom ring.
Anyway, couldn't find a wiring diagram, so I tried various ways until one worked.
I built two of these and wired them both the same way.

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Amp model identification
Next Topic: K-250-4 Output
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Sun Aug 11 18:35:36 EDT 2024