VintageKustom.com: Comment Board » Audio Power Module KPN 200 -0167 in X2-15 B

Home » VintageKustom.com » Comment Board » Audio Power Module KPN 200 -0167 in X2-15 B (Looking for knowledge/help with combo of K200B 1 with audio power module)

Show: Today's Messages :: Polls :: Message Navigator

Audio Power Module KPN 200 -0167 in X2-15 B [message #27820]

Sat, 25 July 2020 17:59

rone
Messages: 2
Registered: July 2020

Junior Member

Hello Vintage Kustom Leaders and Fans,

I have purchased a K200B 1 amp and a x2-15B speaker cabinet and speakers from different sources. The speaker cabinet has a Audio Power Module KPN 200 - 0167 installed.

I thought that the K 200 amp would be compatable with the audio power unit, but I was wrong.

Looking for suggestions as to if I should remove or bypass the audio power unit or if there is another way that these units were designed to work together?

I use to have what i thought was a similar set up in the 60s and that is a poor knowledge base from which to work.

Any information that you can share will be greatly appreciated. It has been a long time to get this far and I would like to get the amp and speaker working.

Do you know what a x2 - 15B speaker cabinet with the KPN 200 - 0167 audio power module was orginaly designed to be used for?

Thank you,

RONE

Report message to a moderator

Re: Audio Power Module KPN 200 -0167 in X2-15 B [message #27822 is a reply to message #27820]

Mon, 27 July 2020 05:58

stevem
Messages: 4775
Registered: June 2004
Location: NY

Senior Member

So let me get this straight, you have only one speaker cabinet, and that's the one with what Kustom called a power module in it?

Those cabinets was for the later 1971 and up 250 series amps that you could up grade to a 500 series with the added self powered cabinet.

If you only have this one cabinet then you have a choise, either get a adapter cable to go from the RCA jack on the rear of your 200 head into the input on the powered cabinet, or remove the rear of the cabinet unhook it's speaker cable from the amp and unhook its input jack wires from the amp and the solder those speaker wires to that 1/4" jack that was the input to the amp.
Then your 200 head can power those speakers.

Note that most of those 2-15" powered cabinets that where sold where for Bass, so if your intent is to play guitar thru it, it may lack some high end to you.

PS, you can run the 200 head without a speaker load on it and no harm will come to it.

[Updated on: Mon, 27 July 2020 06:01]

Report message to a moderator

Re: Audio Power Module KPN 200 -0167 in X2-15 B [message #27823 is a reply to message #27822]

Mon, 27 July 2020 16:48

rone
Messages: 2
Registered: July 2020

Junior Member

Hello and thank you very much for your reply. Yes it is only one speaker cabinet with 2 15 bass speakers. Thanks for the advice, I will disconnect the power supply and run directly to the speakers. I appreciate what you said about missing some of the highs, but I think I am already missing the upper frequencies as it is (lol), so hopefully it should be fun and good. Also good to know how that cabinet was meant to be used. Sounds like it could have been a beast.

I will make the changes and fire it up and hopefully report success soon.

Thank you again,

Rone

Report message to a moderator

Re: Audio Power Module KPN 200 -0167 in X2-15 B [message #29016 is a reply to message #27820]

Mon, 10 April 2023 03:13

Music_nubei
Messages: 2
Registered: April 2023

Junior Member

I have two of these speakers and I'm so curious as to how to get them to work together. Also curious as to the value of such a speaker. I can't find anything about them.

Report message to a moderator

Re: Audio Power Module KPN 200 -0167 in X2-15 B [message #29017 is a reply to message #27820]

Mon, 10 April 2023 03:15

Music_nubei
Messages: 2
Registered: April 2023

Junior Member

I too am super curious about these speakers I can't find any information about them anywhere but I have two of them I'm afraid to hook them up wrong but I want them to work together how would I do this I'm also curious as to their value again I can't find anything about them anywhere. Please help.

Report message to a moderator

Re: Audio Power Module KPN 200 -0167 in X2-15 B [message #29018 is a reply to message #27820]

Mon, 10 April 2023 06:18

stevem
Messages: 4775
Registered: June 2004
Location: NY

Senior Member

I can't provide you any help unless I know what amp you have that you play thru?

Report message to a moderator

Re: Audio Power Module KPN 200 -0167 in X2-15 B [message #29341 is a reply to message #27820]

Thu, 19 September 2024 06:37

johnnysynth
Messages: 46
Registered: June 2018

Member

Hi Rone:
The audio power module you have (KPN 200-0167 was designed to work with Kustom amps that have a "line out" or "to power module" output plug. The Kustom 250 series amps all had that feature. If you don't want that unit I need one. . .

Report message to a moderator

Previous Topic:	Power supply cord problem
Next Topic:	What's it worth?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Sun Nov 10 01:33:16 EST 2024