Active Bass and K250 preamp damage [message #27964] |
Wed, 20 January 2021 07:45 ![Go to next message Go to next message](/FUDforum/theme/vk30/images/down.png) |
stevem
Messages: 4768 Registered: June 2004 Location: NY
|
Senior Member |
|
|
Well over a year ago now while at rehearsal and using one of my basses with a 18 volt active preamp I damaged my selectone channel in one of my K250 heads when it started to produce a ton of hiss.
Just over the weekend I got to look into the issue and had to replace the 14 pin duel section IC chip to fix it.
So you folks with active preamps in your guitars and or using stomp boxes that can add to signal input levels in to the amp beware of driving these 250 and K150 heads with too much signal into them!
These amps where not made to need that hot a input signal level to drive them to full output wattage.
[Updated on: Wed, 20 January 2021 07:48] Report message to a moderator
|
|
|
|
Re: Active Bass and K250 preamp damage [message #29241 is a reply to message #27964] |
Tue, 07 May 2024 06:48 ![Go to previous message Go to previous message](/FUDforum/theme/vk30/images/up.png) |
stevem
Messages: 4768 Registered: June 2004 Location: NY
|
Senior Member |
|
|
In 72 due to complaints from guitar player a circuit change was put in place on the 250 and 150 amps to provide more gain.
This worked great for the guitar player, but I find that for bass I like the pre 72 non mod better , there more dynamic range for bass use and as such less chance of driving the amp into clipping
If you have one of these amps it's all of 5 bucks worth of parts to put it back to it original production form.
Another thing that helps when you have a active bass with hot output is to run the volume on the bass down to 3/4s or less and turn the amp up more.
|
|
|