VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.

Home » VintageKustom.com » Comment Board » Speaker ohms (silvertone amp/Kustom caninet)
Show: Today's Messages :: Polls :: Message Navigator
Switch to threaded view of this topic Create a new topic Submit Reply
Speaker ohms [message #26278] Tue, 29 August 2017 11:04 Go to next message
Iowa Boy is currently offline  Iowa Boy
Messages: 767
Registered: June 2014
Senior Member
Hoping someone here can help me out. Just purchased my childhood guitar amp head, Silvertone 1465. I can't find any information as to the ohms on this thing. I know it originally came with the (6) 10 inch Jensen speakers and assume they were 25 to 30 watts each. I have a Kustom slant 2-15's cabinet that I am going to redo with 15 inch woofer, 2-10 inch midrange, and a horn and crossover. Anyone got any idea's what the ohms of this amp might have been? I've Googled but can't kind anything other than a place to purchase a schematic for the head.
Re: Speaker ohms [message #26279 is a reply to message #26278] Tue, 29 August 2017 12:44 Go to previous messageGo to next message
chicagobill
Messages: 2006
Registered: April 2003
Senior Member
The speakers were wired in series parallel. Three 8 ohm speakers in parallel give you 2.67 ohms. The two sets in series give you 5.34 ohms total.

I would imagine that a 4 ohm load would work well.
Re: Speaker ohms [message #26280 is a reply to message #26279] Tue, 29 August 2017 14:37 Go to previous messageGo to next message
Iowa Boy is currently offline  Iowa Boy
Messages: 767
Registered: June 2014
Senior Member
Thanks Bill, I wasn't sure exactly what the ohms might have been since I kind of remember there were a few amps back then that were 6 ohms as well.
Re: Speaker ohms [message #26281 is a reply to message #26278] Wed, 30 August 2017 06:09 Go to previous message
stevem is currently offline  stevem
Messages: 4773
Registered: June 2004
Location: NY
Senior Member
Be carefull with that amp as if I recall right the heat sinks on the rear that mount each output Transistor are sitting at power supply voltage , so for instance if you drop or touch a 1/4" steel cased speaker jack across the heat sink and the chassis you will short out the power supply!
These amps where rated at 150 watts , but that was peak power as back then with the Transistors of the day there was no way in Hell that two output Transistors where going to make 150 watts!
It's does however use a 5 amp fuse which I find a tad high for safety!

The good thing about those 6-10" cabs is that they stiffen up those crappy 1/4" Masonite baffle board that Dan Electro used , the baffle on my 2-12" 1484 amp with only 35 watts RMS flaps around a lot!

[Updated on: Wed, 30 August 2017 06:13]

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: "Yard Sale" K100C-8 Redone
Next Topic: 3-15's cabinet
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Sun Nov 03 22:51:39 EST 2024