| Capacitor found in Kustom 200A Guitar Amp Cabinet [message #28055] |
Wed, 24 February 2021 18:18  |
ampguy
Messages: 13
Registered: October 2008
|
Junior Member |
|
|
Here's a question for the Kustom Amp experts: I have a 1969 Kustom 200A Guitar Amp with 15 " Jensens. I realized recently that one of the 15 inch speakers was not functioning. When I opened up the amp, I found that mice had gotten into the amplifier during the ownership of the previous owner and chewed through two of the wires going to the coil of one of the speakers. So I had the wires re-soldered at a speaker shop. Can anyone tell me what the capacitor that is attached to the cabinet was used for and whether it's necessary to be hooked up? It was not hooked up when I opened the cabinet, but I figure there's a purpose for it. It appears to be original to the cabinet.
AMPGUY
|
|
|
|
|
|
|
|
|
|
| Re: Capacitor found in Kustom 200A Guitar Amp Cabinet [message #28060 is a reply to message #28056] |
Fri, 26 February 2021 09:54  |
ampguy
Messages: 13
Registered: October 2008
|
Junior Member |
|
|
The mice made a nest in the bottom of the amp. I removed the fluff pile and pulled the top speaker for repair and took it to a shop. They noticed droppings in between the cone and the frame and that the wires had been chewed. This was repaired and the speaker sounds great.
The capacitor was attached with a plate between the speakers on the cabinet. It was not hooked up when I opened the cab to address the dead speaker issue. It is still not hooked up. I could attach a picture, but can't find a way to do it.
AMPGUY
|
|
|
|
|
|
|
|
| Re: Capacitor found in Kustom 200A Guitar Amp Cabinet [message #28063 is a reply to message #28055] |
Fri, 26 February 2021 11:45 |
stevem
Messages: 4774
Registered: June 2004
Location: NY
|
Senior Member |
|
|
Nope! Those tall cabinets could be had for Bass usage with CTS. altec or JBL drivers, or for guitar with 3 of the C15L drivers or for keyboards and PA usage with a siren Round horn and whatever driver up grades you want.
Once late 1970 came about these cabinets where no longer tapered top to bottom and they came fitted with a Altec cast Aluminum sectoral horn and a Altec driver opposed to the a university driver used on the siren set up.
You could even get a cabinet with 2-15s and 2-10" drivers or a rare 3-12" cabinet.
You should go look at this site's literature section.
A original 3-15" cabinet would have had all the 16 ohm driver wired in parallel for a 5.3 ohm total load and inturn some 28 more watts of clean power.
[Updated on: Fri, 26 February 2021 11:48] Report message to a moderator |
|
|
|
VintageKustom.com
Search
Help
Members
Register
Login
Home
]