Kombo II Parts [message #26770] |
Fri, 22 June 2018 13:39 ![Go to next message Go to next message](/FUDforum/theme/vk30/images/down.png) |
Trumpet Man
Messages: 2 Registered: June 2018 Location: Arkansas
|
Junior Member |
|
|
Greetings all.
I browsed the posts in this forum for my topic and did not have any luck. So here is my issue.
I have a 1974 Kombo II that is in pretty good condition, except the mouse family that lived in it for a short while before I bought it left some corroded traces on the Summing Board. There is about 12" of surface trace that I am remediating or jumper bypassing. The C keys have a deficit in the first generation tone signal. A couple of transistor pairs and their resistors are bad and I'm replacing.
However, does anyone have a supply of old stock boards for these that anyone is aware of?
Thanks,
Trumpet Man
|
|
|
Re: Kombo II Parts [message #26771 is a reply to message #26770] |
Sat, 23 June 2018 06:40 ![Go to previous message Go to previous message](/FUDforum/theme/vk30/images/up.png) ![Go to next message Go to next message](/FUDforum/theme/vk30/images/down.png) |
stevem
Messages: 4758 Registered: June 2004 Location: NY
|
Senior Member |
|
|
sorry to say that I think your only hope is a donor kombo II .
That being said , we have the schematics here on the site so I can't see why you can't just hard wire it and use some bread boards if nessary to get it back up and running, yes I agree it' sounds like a project, but it's doable!
[Updated on: Sat, 23 June 2018 06:43] Report message to a moderator
|
|
|
Re: Kombo II Parts [message #26772 is a reply to message #26771] |
Sat, 23 June 2018 20:22 ![Go to previous message Go to previous message](/FUDforum/theme/vk30/images/up.png) |
Trumpet Man
Messages: 2 Registered: June 2018 Location: Arkansas
|
Junior Member |
|
|
Thanks. I have the schematics and the maintenance manual and I am in the process of replacing parts and surface jumper installation. I would be interested in a donor Kombo II if one was out there.
Thanks.
|
|
|