VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.

Home » VintageKustom.com » Repairing Kustom Amps » Kustom 100 blowing fuse (Kustom 100 )
Show: Today's Messages :: Polls :: Message Navigator
Return to the default flat view Create a new topic Submit Reply
Re: Kustom 100 blowing fuse [message #27356 is a reply to message #18016] Thu, 06 June 2019 01:36 Go to previous messageGo to previous message
chicagobill
Messages: 2006
Registered: April 2003
Senior Member
I checked my board and there are 4 tantalum caps on there. Looking from the filter cap side of the board, there are 2 27uF caps in the center of the board. They both mount with the positive leads facing towards the filter caps.

At the lower right side of the board there is a 1uF cap with the positive side towards the filter caps.

Nearby is a 33uF cap that has the positive side facing away from the filter caps.

I've sometimes been able to grind away some of the epoxy filler from the bottom of the 1N3754 diode around the broken off lead. Just enough to solder a wire to the stub end. I would suggest that for the time being just replace it with a 1N4148 or similar diode until you get the problems straightened out. In fact you could just use a jumper wire to replace it for the time being.

Still looking at the board from the filter cap side, the two driver transistors are located at the upper left side. The outermost one should be a 128 and the inner one should be the 129.
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: K200A-1 Power Amp Rescue Needed
Next Topic: Kustom III lead pc board 5065 rev2
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Mon Nov 18 18:18:47 EST 2024