VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.

Home » VintageKustom.com » Repairing Kustom Amps » Kustom 100 blowing fuse (Kustom 100 )
Show: Today's Messages :: Polls :: Message Navigator
Return to the default flat view Create a new topic Submit Reply
Re: Kustom 100 blowing fuse [message #18017 is a reply to message #18016] Tue, 08 January 2013 10:39 Go to previous messageGo to previous message
stevem is currently offline  stevem
Messages: 4775
Registered: June 2004
Location: NY
Senior Member
Welcome!
Yes, your problem is likly to be the same and likly to be a blown output transistor( TO3 type mounted on chassis heat sink) which sometimes also takes out its driver transistor(TO5 type in heat sink box on driver board)when it pops.
Also likly to be bad would be the 5 watt resistor associtaed with that side of the output stage.
Your rectifier bridge diode may also be bad, this is the round case 4 terminal item bolted down to the chassis near the power transformer.
A good way to check that is to unhook the red and green wires that come from it from there termination point on each power supply filter.
When unhooked and place out of the way from shorting, replace the fuse and turn on the amp, if the fuse holds them you know that the power supply is ok and the problem resides in the output stage/driver section of the amp.
You could also disconnect the output side of each power supply filter(red and green wire) and do the same test.
Do not hook up a test speaker to the amp until you have it fixed and the steady state DC reads less than 1 volt on the amps speaker output other wise the 40 volts of DC output can blow your speakers.
Inform us on your progress, or if you need more help.
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: K200A-1 Power Amp Rescue Needed
Next Topic: Kustom III lead pc board 5065 rev2
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Tue Nov 12 23:07:38 EST 2024