VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.

Home » VintageKustom.com » Comment Board » Repair advise (k200 A-4 )
Show: Today's Messages :: Polls :: Message Navigator
Return to the default flat view Create a new topic Submit Reply
Re: Repair advise [message #19146 is a reply to message #19064] Thu, 15 August 2013 15:17 Go to previous messageGo to previous message
chicagobill
Messages: 2005
Registered: April 2003
Senior Member
The white Mallory caps are electrolytic capacitors. Mallory has been out of the cap business for about 20 years now. Almost all of the modern caps are made in the far East. Sprauge, Nichicon, Panasonic are a few names of current manufacturers.

Electrolytic caps are one of the common parts that are known to go bad. A lot of it depends upon how the amp was stored and used, but they can dry out and go open circuit or worse short circuit.

Any modern cap you find will probably be half the size of the old ones. Just make sure that you get the correct values for capacitance in microfarads (uF), and voltage ratings. There are two styles of cases/mounting, Axial where the leads come off of the ends of the casing for horizontal mounting and Radial where the leads come off of one end of the cap for vertical mounting.

There are 8 electrolytic capacitors on the preamp board: 4-10uF, 3-25uF and 1-100uF. The only value that is different from modern values is the 25uF, you will more likely find 22uF caps. Use the 22uF value if that is what you find.

The voltage ratings should be a minimum of 25 volts. The one 100uF cap is a filter cap, the rest are used in the audio circuits.

When you replace the electrolytics, be sure to install them in the correct orientation, as they are polarized. They will all be marked with either a plus or a minus sign pointing to one of the legs. Make note of how the original ones were installed, and install the new one the same way.

As far as the smaller value caps, these are all mylar film types and should not need replacement.
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Kustom 415B
Next Topic: Kustom logo for covers
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Mon Aug 05 09:07:38 EDT 2024