VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.
Home » VintageKustom.com » Repairing Kustom Amps » Replacement for a PET8002 transistor
Show: Today's Messages :: Polls :: Message Navigator
Switch to threaded view of this topic Create a new topic Submit Reply
Replacement for a PET8002 transistor [message #25441] Thu, 18 August 2016 22:05 Go to next message
gregp is currently offline  gregp
Messages: 13
Registered: August 2016
Junior Member
So I found this lengthy list of cross referenced transistors for the PET8002.

Ive checked half of them, even the NTE123 and NONE show up on Mouser??

Whats a new world equivalent I can actually order?

Report message to a moderator

Re: Replacement for a PET8002 transistor [message #25442 is a reply to message #25441] Thu, 18 August 2016 22:17 Go to previous messageGo to next message
gregp is currently offline  gregp
Messages: 13
Registered: August 2016
Junior Member
heck I just order 2n3904s...... hope they'll do?

Report message to a moderator

Re: Replacement for a PET8002 transistor [message #25443 is a reply to message #25441] Fri, 19 August 2016 02:03 Go to previous messageGo to next message
chicagobill
Messages: 2006
Registered: April 2003
Senior Member
Yes, the 2N3904 will probably work just fine. I usually use the 2N4401.

The NTE123ap is the current NTE part number, which I think is still available. I don't use the NTE parts myself, as they are far too expensive compared to the generic numbers.

Report message to a moderator

Re: Replacement for a PET8002 transistor [message #25445 is a reply to message #25441] Fri, 19 August 2016 10:29 Go to previous messageGo to next message
gregp is currently offline  gregp
Messages: 13
Registered: August 2016
Junior Member
By the way.... anyone happen to know what the RCA jack on the upper right rear is for?

Havent looked at a schematic yet

Report message to a moderator

Re: Replacement for a PET8002 transistor [message #25446 is a reply to message #25441] Fri, 19 August 2016 10:42 Go to previous message
stevem is currently offline  stevem
Messages: 4775
Registered: June 2004
Location: NY
Senior Member
Was for feeding a tape recorder and will pump out up to 3 volts of signal if the amp is cranked so you can do what you want with it!

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: Kustom PC 102 Organ
Next Topic: New K200 owner, some guidance needed
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Mon Nov 18 11:06:03 EST 2024
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software