My new cab [message #26450] |
Mon, 08 January 2018 22:07 ![Go to next message Go to next message](/FUDforum/theme/vk30/images/down.png) |
Buzzbom79
Messages: 2 Registered: January 2018
|
Junior Member |
|
|
Hi, I purchased a cab from a friend. It has 2x12s. The only descriptive numbers that I see are on the speaker magnets.
There at 3 sets. 1) 5815113. 2) 137 6913. 3) 038-0004-00.
Any help with model#, ohms, watts would be appreciated.
Also another friend has a Peavy standard pa mixer amp series 260.
It has 2 inputs which are both 4ohms.
He tells me it should work with this cab as a head. Is this true?
Btw itll be used for a bass and this is my first time with any cab/head
so I apologize if I missed something that's obvious.
|
|
|
|
|
|
Re: My new cab [message #26458 is a reply to message #26450] |
Sat, 13 January 2018 06:24 ![Go to previous message Go to previous message](/FUDforum/theme/vk30/images/up.png) |
stevem
Messages: 4769 Registered: June 2004 Location: NY
|
Senior Member |
|
|
Some corrections first.
The 130 watts labeled on the rear of the amp is the amps RMS output power and those are the output jacks , not the input jacks like you posted, the 400 watts labeled on the rear is how much power the amp draws from the wall outlet to produce that 130 watts.
I would recommend to you a Eminence brand driver that you can get from parts express.
It's part number 290-414 and cost 80 bucks each.
These are the only true Bass drivers I could find who's Vas spec is close to working with that size cabinet, all the other Bass drivers I found need a far far bigger cabinet!
Another option for you would be if your blown drivers are the square magnet CTS bass drivers you could send them out to Weber and get them re- coned, but with a higher power handling voice coil then what they where made with.
Cost wise once you figure in the shipping you may only save 10 bucks or so going this route.
[Updated on: Sat, 13 January 2018 06:27] Report message to a moderator
|
|
|