VintageKustom.com: Comment Board » What to connect Kustom K250-4

Home » VintageKustom.com » Comment Board » What to connect Kustom K250-4

Show: Today's Messages :: Polls :: Message Navigator

Re: What to connect Kustom K250-4 [message #9233 is a reply to message #9232]

Fri, 15 February 2008 10:47

chicagobill
Messages: 2006
Registered: April 2003

Senior Member

Weclome to the board Frans.

Yes you can use more then one cabinet as long as the total load stays around 3-4 ohms. Anything less, and you may overheat the power amp. I believe that your amp has 2 speaker jacks on the back.

As for the "Module" output, this is a low level signal and not a speaker output. It is for driving the input of a power amp. Back in the 70's Kustom made speaker cabinets with built in power amps that could be added to your system to increase the total power/watts of output. This way you could control 2, 3 or 10, 100watt amps from one control panel (head).

Again, welcome!

Report message to a moderator

[Message index]

		What to connect Kustom K250-4 By: frans on Thu, 14 February 2008 11:11
		Re: What to connect Kustom K250-4 By: stevem on Thu, 14 February 2008 12:33
		Re: What to connect Kustom K250-4 By: frans on Fri, 15 February 2008 10:35
		Re: What to connect Kustom K250-4 By: chicagobill on Fri, 15 February 2008 10:47
		Re: What to connect Kustom K250-4 By: frans on Fri, 15 February 2008 15:59
		Re: What to connect Kustom K250-4 By: chicagobill on Fri, 15 February 2008 18:08
		Re: What to connect Kustom K250-4 By: johnnysynth on Tue, 06 August 2019 07:30
		Re: What to connect Kustom K250-4 By: stevem on Mon, 18 February 2008 06:28

Previous Topic:	Kustom Column info
Next Topic:	Impedence of JBL D140F

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Sun Nov 17 00:23:41 EST 2024