VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.
Home » VintageKustom.com » Replacement Part Suggestions » Speaker install - Kustom 3 tower
Show: Today's Messages :: Polls :: Message Navigator
Switch to threaded view of this topic Create a new topic Submit Reply
Speaker install - Kustom 3 tower [message #24647] Thu, 18 February 2016 11:18 Go to next message
jimbpilot is currently offline  jimbpilot
Messages: 9
Registered: January 2016
Location: Conroe, Texas 77303
Junior Member
Does anyone know what ohm load you end up with if you install 2 JBL D-140's rated at 16 0hm each with 1 JBL D-140 rated at 8 ohm if all wired in parallel ?? We are rejuvenating an old Kustom JBL three tower bass cabinet and K200 bass amp top.
JB

Jjim Buick

Report message to a moderator

Re: Speaker install - Kustom 3 tower [message #24649 is a reply to message #24647] Thu, 18 February 2016 14:39 Go to previous message
chicagobill
Messages: 2006
Registered: April 2003
Senior Member
The impedance would be 4 ohms, but the power will not divide evenly between the three speakers. The 8 ohm would get 1/2 of the amps power and each 16 ohm would get 1/4.

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: K250 1
Next Topic: Speaker replacement
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Wed Nov 06 18:04:36 EST 2024
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software