K200-B1 load [message #6284] |
Mon, 31 October 2005 14:22 |
madcompton
Messages: 1 Registered: October 2005 Location: Portland
|
Junior Member |
|
|
I fear I may have blown out a perfectly good Traynor cabinet with my K200-B1. I have no labels on the back of the amp and wanted to double check what load the amp is looking for, and if its the same for both speaker jacks.
-Madison
|
|
|
Re: K200-B1 load [message #6285 is a reply to message #6284] |
Tue, 01 November 2005 08:07 |
stevem
Messages: 4772 Registered: June 2004 Location: NY
|
Senior Member |
|
|
The amp puts out 100 watts RMS into a 8 ohms, and will run fine into a 4 ohm load or a 16 ohm load. But into a 16 ohm load the head will only output about 60watts RMS. to test your speakers Plug a cord into your speaker cab and apply a 9 volt battery to the other end, put the small terminal of the battery to the tip of the 1/4" jack and the large terminal to the jacks sleve or case and you should hear a good pop from the speakers if they are good.
|
|
|