VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.

Home » VintageKustom.com » Repairing Kustom Amps » K150-6 pumps out DC voltage when powered on.
Show: Today's Messages :: Polls :: Message Navigator
Return to the default flat view Create a new topic Submit Reply
Re: K150-6 pumps out DC voltage when powered on. [message #27661 is a reply to message #23707] Wed, 12 February 2020 17:32 Go to previous messageGo to previous message
corybrown is currently offline  corybrown
Messages: 51
Registered: August 2015
Member
Thank you again for all the help so far.

I'll fill you in on the progress that I made last night.

After trying the amp again and verifying that it still had 27 volts DC showing on the output jack I went back through all of the previous suggestions.

I turned the amp on and using a wooden probe I pushed around on all of the components on the poweramp board and various other wired connections throughout the chassis.

That didn't seem to affect it.

Then I unhooked and removed the two big blue filter caps and reinstalled. I tested them while they were out and they tested fine.

That didn't seem to affect it.

I removed transistors Q18 and Q19 and tested them with multimeter. They tested at 585mV when testing base to collector and base to emitter. I then reinstalled them.

That didn't seem to affect it.

I came home today and saw your post and went to check on it again.

This time when I fired it up to verify if the 27V was still there so that I could begin testing and it metered at 0V.

So I hooked the speaker back up and tried it and it worked perfectly. That lasted for a good 5 minutes and then it made a popping sound and resumed the hum.

The 27V is now back on the output jack.

I don't know if this matters or not but I tested the monitor jack that is on the back panel and it does not have 27V on it.

I tried again manipulating the poweramp board and components with the wooden probe and so far no luck.

Thanks

[Updated on: Wed, 12 February 2020 17:34]

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: K100 2 Questions
Next Topic: Reducing the high frequency hiss on Frankie heads
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Tue Nov 05 19:50:04 EST 2024