VintageKustom.com: Repairing Kustom Amps » Kustom Organ Effects Loop

Home » VintageKustom.com » Repairing Kustom Amps » Kustom Organ Effects Loop (How to create an effects loop in a Kutsom Combo Organ)

Show: Today's Messages :: Polls :: Message Navigator

Re: Kustom Organ Effects Loop [message #27154 is a reply to message #27152]

Mon, 07 January 2019 12:07

stevem
Messages: 4772
Registered: June 2004
Location: NY

Senior Member

If you go into this sites tech section and pull up the schematic for the combo or organ, then go to page 9 and on the lower right side above the info box you will see the output marked as " to power amp"
This is where you want to break the signal chain open which is this hot lead so to speak and install a jack on each end.
Your ground for each jack will be the chassis.

[Updated on: Mon, 07 January 2019 12:24]

Report message to a moderator

[Message index]

		Kustom Organ Effects Loop By: Sahara on Sun, 06 January 2019 17:31
		Re: Kustom Organ Effects Loop By: stevem on Mon, 07 January 2019 12:07
		Re: Kustom Organ Effects Loop By: Sahara on Mon, 07 January 2019 15:08
		Re: Kustom Organ Effects Loop By: Sahara on Mon, 07 January 2019 16:10
		Re: Kustom Organ Effects Loop By: stevem on Tue, 08 January 2019 06:02
		Re: Kustom Organ Effects Loop By: rodak on Tue, 08 January 2019 09:48

Previous Topic:	Kustom 100 issues
Next Topic:	K200B DC voltage on speaker repair

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Thu Oct 03 14:20:01 EDT 2024