VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.

Home » VintageKustom.com » Repairing Kustom Amps » K100-2 Reverb Issue (Reverb doesn't work - return OK but send apparently no good)
Show: Today's Messages :: Polls :: Message Navigator
Return to the default flat view Create a new topic Submit Reply
K100-2 Reverb Issue [message #26881] Fri, 17 August 2018 01:02 Go to previous message
Lovguitar is currently offline  Lovguitar
Messages: 15
Registered: August 2018
Junior Member
I have become somewhat obsessed with Kustom Amps and picked up a "supposedly" properly working amp on ebay. Turns out that the volume is fine, noise floor is fine, trem works really well but reverb is broken. When you turn up the reverb control all you get is loud hum. If you bang the tank you hear it through the amp pretty loudly, so we know that the return side works. Previous owner replaced the tank with a much smaller tank which may or may not be proper. When I substituted in a good known tank it hummed just like the replacement. I should have sent it back but now I'm hooked on wanting to fix them!!!!!!

The pc104 board does not have female rca jacks mounted on it for the reverb. It has coaxial wire with one side directly soldered to the board and the other side terminating in a male rca jack. The "send" jack is hooked up oddly and it makes no sense to me. The "hot" wire is soldered to the board and the shield contacts the hot wire, so both the hot side of the male plug and the "shield" side of the plug are connected together.

I've looked carefully at the schematic and can't make hide nor hair of the reverb. There's a rectangle marked reverb with arrows pointed away from the tank on both sides.

I'd appreciate some help with this please. I'd love to get this working right -- for the principle of the thing and to have a spare working k100-2.

Thanks in advance!!

Paul
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: K200B-2 Both Preamps bad?
Next Topic: K200B-2 tremolo is weak and pops when switched
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Sat Nov 02 09:09:47 EDT 2024