VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.

Home » VintageKustom.com » Comment Board » Kustom V Mixer ( flat base unit ) (Operator Hookup Manual / Schematic)
Show: Today's Messages :: Polls :: Message Navigator
Switch to threaded view of this topic Create a new topic Submit Reply
Kustom V Mixer ( flat base unit ) [message #27479] Sun, 01 September 2019 17:39 Go to next message
jammy5152 is currently offline  jammy5152
Messages: 62
Registered: May 2018
Location: Georgia
Member

Hi
I am looking for a Kustom V Schematic and Hookup Paper / Book
Any clues out there?..
This mixer sits flat on table and even has a reverb tank installed inside
It has mono " main " and mono " monitor "
It has Echo input 1/4 on the back with others too
It is a 6 input mixer...
Re: Kustom V Mixer ( flat base unit ) [message #27480 is a reply to message #27479] Mon, 02 September 2019 06:11 Go to previous messageGo to next message
stevem is currently offline  stevem
Messages: 4775
Registered: June 2004
Location: NY
Senior Member
Is your main question pretending to how to use it/ set it up?
Re: Kustom V Mixer ( flat base unit ) [message #27481 is a reply to message #27480] Mon, 02 September 2019 13:04 Go to previous messageGo to next message
jammy5152 is currently offline  jammy5152
Messages: 62
Registered: May 2018
Location: Georgia
Member

Steven
Yes... that is part of it.... also a schematic to see why monitor roars when Volumn is increased too...
It needs cleaning and pots need cleaning
Re: Kustom V Mixer ( flat base unit ) [message #27482 is a reply to message #27480] Mon, 02 September 2019 13:07 Go to previous messageGo to next message
jammy5152 is currently offline  jammy5152
Messages: 62
Registered: May 2018
Location: Georgia
Member

Steven
Yes... a schematic too beside the basic setup
The reverb sounds great in this Mixer...
Re: Kustom V Mixer ( flat base unit ) [message #27488 is a reply to message #27479] Wed, 04 September 2019 06:03 Go to previous messageGo to next message
stevem is currently offline  stevem
Messages: 4775
Registered: June 2004
Location: NY
Senior Member
I do not have a schematic for this mixer and it seems neither does our archive here on this site.
Does the mixer have a issue besides the scratchy control pot?

If you open it up and make note of the PC board numbers there might be a PC board close to being the same on this site.
Re: Kustom V Mixer ( flat base unit ) [message #27680 is a reply to message #27480] Sat, 22 February 2020 16:13 Go to previous messageGo to next message
jammy5152 is currently offline  jammy5152
Messages: 62
Registered: May 2018
Location: Georgia
Member

I'm just trying to do a basic hookup with this mixer....
It has a Mono Main / 1/4 input...
It has a Mono Monitor Main 1/4 jack input....
It has an Echo 1/4 jack input...I can figure this all these inputs but it has other inputs too...

[Updated on: Sat, 22 February 2020 16:14]

Report message to a moderator

Re: Kustom V Mixer ( flat base unit ) [message #27682 is a reply to message #27479] Mon, 24 February 2020 07:19 Go to previous messageGo to next message
stevem is currently offline  stevem
Messages: 4775
Registered: June 2004
Location: NY
Senior Member
One of my bands back in the early 70s had one of these mixers and it was made to be used with powered speakers that each contained 2-15" drivers and a Altec type horn as I recall.

These where very basic mixers and I don't even think that there main and monitor outputs where balanced low impeadance, but I could be wrong after all these years!

Other then the issue that it seems your monitor section of the mixer has I can't see what your questioning in regards to running the unit.

You just send the mixers output into a power amp and then the power amp out to speaker!

Many power amps these days have a combo type input jack that accepts both a XLR input or a 1/4' TRS male end.
You would use the 1/4" input on the combo jack, the only thing is that if I am right about the mixer not being low impeadance then your going to have to Crank the mixer up more as running a unbalanced signal into a balanced input power amp will knock 6 db off the the mixers output level.

[Updated on: Mon, 24 February 2020 07:23]

Report message to a moderator

Woodson W150-2 GuitarAmplifier [message #27727 is a reply to message #27479] Thu, 12 March 2020 16:44 Go to previous message
jammy5152 is currently offline  jammy5152
Messages: 62
Registered: May 2018
Location: Georgia
Member

I just got hold of a Woodson W150-2 Guitar Amplifier which was part of the Kustom Series in the 70's
This amp uses the same circuitry as the Kustom amps and was another part of the series like Plush, Kasino, Kustom etc
I am looking to get a schematic if anyone knows where that can be found
  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: Introduction + Request (Kustom 88 Piano)
Next Topic: K200 Frankenstein L795 Bass or guitar amp?
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Sat Nov 16 12:39:47 EST 2024