K8023 T&R cabinet [message #21481] |
Tue, 16 September 2014 19:15 ![Go to next message Go to next message](/FUDforum/theme/vk30/images/down.png) |
tito566
Messages: 45 Registered: August 2013
|
Member |
|
|
Hey there, back for more info/advice. I just picked up a k200b-2 with the above speaker configuration. Were these a common offering from Kustom? Also the speakers it came with are 2-10 CTS original as they're stamped with the kustom name and 2-12 jensens. I assume someone replaced the 12's or could it be that some cabs come with a combination of branded speakers. Thanks as always.
|
|
|
|
|
|
|
Re: K8023 T&R cabinet [message #21489 is a reply to message #21487] |
Wed, 17 September 2014 07:40 ![Go to previous message Go to previous message](/FUDforum/theme/vk30/images/up.png) ![Go to next message Go to next message](/FUDforum/theme/vk30/images/down.png) |
tito566
Messages: 45 Registered: August 2013
|
Member |
|
|
Thanks Braud- thats good to know. My jensens are the same model number as yours so maybe everything is stock. Not that it matters much in my mind, just was curious about it. I did mention the magnets were different from the ones in my 2-15 cab but that is also from the older Ross inc era. All the insight I get here is much appreciated.
|
|
|
|
Re: K8023 T&R cabinet [message #21491 is a reply to message #21490] |
Wed, 17 September 2014 13:06 ![Go to previous message Go to previous message](/FUDforum/theme/vk30/images/up.png) ![Go to next message Go to next message](/FUDforum/theme/vk30/images/down.png) |
tito566
Messages: 45 Registered: August 2013
|
Member |
|
|
Thank you Steve and pleat as well for the earlier input. After firing up the k200b-2 head, I found there to be a good amount of hissing going on. After reading past posts on this issue, seems it's pretty common so I'll be doing some troubleshooting tonight. Any advice is welcome as always. In addition, the left channel bright switch affects the sound when in the On position. It seems to cut the output down considerably. Thanks again all!
|
|
|
Re: K8023 T&R cabinet [message #21492 is a reply to message #21481] |
Wed, 17 September 2014 13:14 ![Go to previous message Go to previous message](/FUDforum/theme/vk30/images/up.png) |
stevem
Messages: 4758 Registered: June 2004 Location: NY
|
Senior Member |
|
|
That switch should be sprayed out with some contact cleaner.
If you run the signal from the RCA jack on the back into another amp is the excess hiss still there, if not than the issue is on the output board , not in one of the two preamps.
|
|
|