VintageKustom.com: Replacement Part Suggestions

Home » VintageKustom.com » Replacement Part Suggestions » Kpm160 mixer (reverb tank replacement)

Show: Today's Messages :: Polls :: Message Navigator

Kpm160 mixer [message #28289]

Mon, 02 August 2021 20:31

TheAnimal
Messages: 1
Registered: August 2021

Junior Member

I have a kpm160a mixer and the reverb tank is toast. I can't find the Belton model that was in it. What can I use for a replacement? Bsn2ebe1a.

Report message to a moderator

Re: Kpm160 mixer [message #28290 is a reply to message #28289]

Tue, 03 August 2021 05:53

stevem
Messages: 4775
Registered: June 2004
Location: NY

Senior Member

Hello and welcome.
Unfortunately this site does not have info for such a new model as you have there.
I would suggest that you get in contact with the customer service dept at the current Kustom company for assistance.

Report message to a moderator

Re: Kpm160 mixer [message #28316 is a reply to message #28289]

Thu, 02 September 2021 13:22

chicagobill
Messages: 2006
Registered: April 2003

Senior Member

Yes, welcome.

I searched for Belton tank codes and went to the Belton website and downloaded the pdf for the BS-series tanks.

B=Stands for Belton
S=Stands for small size
N=New version
2=Two springs

The rest of the codes are for input and output impedance, etc. There seems to be a problem with the code that you wrote down, as it doesn't conform to their format. Is there a space (blank) in the code?

In any case, you should be able to figure out enough from the specs listed at the site to match an available tank.

Good luck.

Report message to a moderator

Previous Topic:	K300 power transformer
Next Topic:	Legend Amplification replacement knobs

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Sat Nov 09 12:36:06 EST 2024