K150-1 Hum No Audio [message #28414] |
Tue, 18 January 2022 16:27 ![Go to next message Go to next message](/FUDforum/theme/vk30/images/down.png) |
TelesnTubes
Messages: 2 Registered: January 2022
|
Junior Member |
|
|
Hello
I am new here. Thanks for sharing so much info on Kustom amps. I am a tube amp guy trying to navigate my fist solid state amp repair. It is a Kustom 150-1 head. Amp is not passing audio and has an audible hum thru my 8ohm test speaker. I have removed the signal input wiring harness plug to see if the problem is in the pre amp or power section. There was no change. So I suspect an issue in the PC5033 power amp board. I have 46 +/- VDC on the big filter caps and 12 +/- on the terminal block and wiring to the preamp boards. I also read 15 VDC on the speaker jack - my experience with tube amps tells me there should not be DC on the speaker output and maybe there is a coupling capacitor that is bad.
I have not started measuring/testing components or voltage at each component yet. I wanted to see if I am on the right track or should I start elsewhere? I also have a question about the correct value for C4. The schematic says 33uf. I wonder if the decimal point is missing and if the correct value is .33uf or 3.3uf. I can't see the code on the capacitor. I have found most of the transistors online except for the 40408/nte190. What is an equivalent for this transistor. I also see the IC and suggested nte725 replacement are obsolete. Any suggestions if these need to be replaced? I hope the issue is contained to the PC5033 board.
Thanks!
|
|
|
|
|
Re: K150-1 Hum No Audio [message #28417 is a reply to message #28414] |
Tue, 18 January 2022 19:19 ![Go to previous message Go to previous message](/FUDforum/theme/vk30/images/up.png) |
stevem
Messages: 4759 Registered: June 2004 Location: NY
|
Senior Member |
|
|
Yes, it's far easier to to stuff in a known good PI tube and set of 6550's once the bias is checked and see if it fly's again!
Note, you will have to make 3 more post for me to approve before your post will just go up to the site.
[Updated on: Tue, 18 January 2022 19:21] Report message to a moderator
|
|
|