VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.
Home » VintageKustom.com » Replacement Part Suggestions » Altec (421-----421A)
Show: Today's Messages :: Polls :: Message Navigator
Switch to threaded view of this topic Create a new topic Submit Reply
Altec [message #23469] Thu, 23 July 2015 14:00 Go to next message
Iowa Boy is currently offline  Iowa Boy
Messages: 767
Registered: June 2014
Senior Member
Anyone know the difference between these two Altec speakers......can't find any specs on just the 421. Thanks

Report message to a moderator

Re: Altec [message #23471 is a reply to message #23469] Fri, 24 July 2015 06:34 Go to previous messageGo to next message
stevem is currently offline  stevem
Messages: 4773
Registered: June 2004
Location: NY
Senior Member
They are the same thing!
The 421 H8 is different being rated a 150 watts program, not 100.

Report message to a moderator

Re: Altec [message #23475 is a reply to message #23469] Fri, 24 July 2015 11:32 Go to previous messageGo to next message
Iowa Boy is currently offline  Iowa Boy
Messages: 767
Registered: June 2014
Senior Member
Thanks for the info........no one else was able to come up with an answer and Altec has been bought out....again......and current company couldn't help me at all.

Report message to a moderator

Re: Altec [message #23477 is a reply to message #23469] Fri, 24 July 2015 11:38 Go to previous messageGo to next message
stevem is currently offline  stevem
Messages: 4773
Registered: June 2004
Location: NY
Senior Member
Go to the Altec heritage site.

Report message to a moderator

Re: Altec [message #23494 is a reply to message #23469] Mon, 27 July 2015 06:39 Go to previous message
stevem is currently offline  stevem
Messages: 4773
Registered: June 2004
Location: NY
Senior Member
I have been doing some deeper digging on this Altec stuff since I have 4 drivers that I need to re- cone and this is what I have found.
Any of the drivers with the II ending in there model have the up rated voice coil that went from 100 watts rms up to 150.
The H used in the model number tells the frequency responce goes from some 35hz up to 8K, others are manly Bass drivers that top out at 3500hz,but there are some small differences in low end spec that I can not pin down with the info I have found.
There are however some big differences in the Vs spec on some of the low frequency drivers with some needing over double the cabinet cu Ft area!

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: 15 inch speaker
Next Topic: Plastic Handle Inserts
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Sat Nov 02 04:39:45 EDT 2024
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software