VintageKustom.com: Replacement Part Suggestions » Kustom 150 Reverb Tank Needed

Home » VintageKustom.com » Replacement Part Suggestions » Kustom 150 Reverb Tank Needed (Bought a plastic faced 150 amp and it is missing the reverb tank. Need help sourcing one. )

Show: Today's Messages :: Polls :: Message Navigator

Kustom 150 Reverb Tank Needed [message #27942]

Sat, 26 December 2020 16:35

Bribot84
Messages: 2
Registered: December 2020

Junior Member

Hey all,
Looking forward a reverb tank for the 150. I also need two mounting bars so I can install it properly. Hoping everything works when plugged back in but have a feeling it's been removed for a reason and might need further work. S anyone know where to find an original tank or what a suitable replacement would be?

Report message to a moderator

Re: Kustom 150 Reverb Tank Needed [message #27947 is a reply to message #27942]

Mon, 28 December 2020 07:11

stevem
Messages: 4773
Registered: June 2004
Location: NY

Senior Member

Hi!
It's very rare that the reverb circuits themselves in the plexiglass face amps have problems, so a new tank should get you back in action.
That tank you need can be had from tubes & more, and is part number P-RMOD-4FB3A1A.

The mounting tubes that where used can be made from 3/8" aluminum or brass tuning, that you flatten the ends out on, but flat Aluminum stock will be easier.

The screws that hold the mounting system to the amp chassis where 6/32.

Note that it's very important to mount the pan in the amp so that the output side of the pan is opposite the amps power transformer.

The quality of the shielding of the cables used makes a difference in the noise level also!

[Updated on: Mon, 28 December 2020 07:14]

Report message to a moderator