Kustom 150 Combo bass amp [message #13686] |
Tue, 18 May 2010 18:45 ![Go to next message Go to next message](/FUDforum/theme/vk30/images/down.png) |
WesternSkies213
Messages: 12 Registered: May 2010 Location: CT
|
Junior Member |
|
|
Hello Everyone,
I have been looking for Bright Switch Tone Knobs for my Kustom 150 combo bass amp for a few years now. Not sure about the year but its an early to mid 70's tuck and roll.
I recently ordered 2 black fluted silver center large dot index knobs from Small Berr Electronics and they don't fit either.
I thought these would be the correct ones before I purchased them.
Does anyone know where I can purchase the correct knobs?
The serach continues.
Thanks,
Craig
|
|
|
|
|
Re: Kustom 150 Combo bass amp [message #13690 is a reply to message #13686] |
Wed, 19 May 2010 12:52 ![Go to previous message Go to previous message](/FUDforum/theme/vk30/images/up.png) ![Go to next message Go to next message](/FUDforum/theme/vk30/images/down.png) |
chicagobill
Messages: 2005 Registered: April 2003
|
Senior Member |
|
|
Are you saying that the knobs don't fit onto the shaft or they don't look right or what?
If it is a physical fit problem, the thing to try is to remove the knob from the volume control, does it fit the bright switch?
Can you post a photo?
|
|
|
|
|
|
|
|
Re: Kustom 150 Combo bass amp [message #13703 is a reply to message #13686] |
Thu, 20 May 2010 13:56 ![Go to previous message Go to previous message](/FUDforum/theme/vk30/images/up.png) ![Go to next message Go to next message](/FUDforum/theme/vk30/images/down.png) |
chicagobill
Messages: 2005 Registered: April 2003
|
Senior Member |
|
|
I have seen it happen when the original set screws have been so over tightened, that the brass shaft of a pot or switch will become chewed up enough to stop a knob from getting past that point on the shaft.
Did they ever make a metal front 150 combo?
|
|
|
|
|
Re: Kustom 150 Combo bass amp [message #13714 is a reply to message #13686] |
Fri, 21 May 2010 05:44 ![Go to previous message Go to previous message](/FUDforum/theme/vk30/images/up.png) |
stevem
Messages: 4748 Registered: June 2004 Location: NY
|
Senior Member |
|
|
On my K100 combo all the knobs are the same, they all use a set screw to hold them on and all of the controls have a 1/4" shaft with the cut back notch/D section at the shafts start.
|
|
|