VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.

Home » VintageKustom.com » Repairing Kustom Amps » need to test K250-1 (Bought a K250-1 on auction, how do I test it?)
Show: Today's Messages :: Polls :: Message Navigator
Return to the default flat view Create a new topic Submit Reply
Re: need to test K250-1 [message #28390 is a reply to message #28376] Sat, 20 November 2021 06:15 Go to previous messageGo to previous message
stevem is currently offline  stevem
Messages: 4756
Registered: June 2004
Location: NY
Senior Member
Ok, the first thing your going to need is to get a hand held tube type solder sucker since your going to need such to get some Transistors and maybe resistors off of the output driver board ( PC 5065 ) on the floor of the amp.

Since you have a meter, set it to ohms .
On the driver board you will see 4 big 5 watt box type ciramic resistors next to each of the 4 output driver Transistors in there heat sinks.
These are very low ohms and should not check open, and many times when the output section has a problem like your amp one or more of these resistors ( called emitter resistors) will over heat and go open.

On the schematic you found in your amp these four are resistors r 23, r25, r33 and r35.

Please report back on your findings and we will move on.

[Updated on: Sat, 20 November 2021 06:17]

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Diodes
Next Topic: K150-1 Hum No Audio
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Tue Aug 06 14:30:26 EDT 2024